General Description; What Is The Nx-100 Setup Program; About Network Settings; Backing-Up Setting Files - Toa NX-100 Installation Setup Manual

Chapter 3: SYSTEM SETTINGS (NX-100 SETUP PROGRAM)

1. GENERAL DESCRIPTION

1.1. What is the NX-100 Setup Program?

This program is used to set all the NX-100 and NX-100S units connected to a LAN. It also provides a simple
display on the PC screen of operating data for multiple NX-100 and NX-100S units connected to a LAN.
Its main features are as follows:
• Scans and displays all NX-100 and NX-100S units connected to a LAN.
• Automatically sets IP addresses without duplication. Permits manual changes as well.
• Permits simultaneous uploading of setting files to two or more NX-100 and NX-100S units.
• Backs up setting files for two or more NX-100 and NX-100S units in a batch.
• Easily and efficiently performs broadcast settings between units.
Note
When setting the unit connected to the Internet, refer to Chapter 4, System Settings (Setting Using Browser).

1.2. About Network Settings

Follow the instructions of the network management personnel before performing network settings for the PC
and connected units. Incorrect settings may adversely influence other units connected to the same network.

1.3. Backing-Up Setting Files

Setting contents, once saved, are saved in the data folder located inside the Setup program's installation
folder (Default path: C:\Program Files\TOA\NX-100) as a unit setting file. If uploaded, these files are stored in
each NX-100 and NX-100S as unit setting files. It is highly recommended that all settings be backed up.
Backing up settings to other locations on the PC hard drive or to external storage devices facilitates
restoration should the NX-100, NX-100S or PC inadvertently fail. To save backup copies, copy the entire data
folder located in the Setup program's installation folder.
Caution
When settings are changed, be sure to update the backup files as well.

1.4. Cautions Concerning Setting Updates

Never restart the NX-100 and NX-100S units nor turn off their power supply while updating* the setting
contents.
* The Status indicator on the unit's front panel flashes during an update.
3-2