Network Installation - Axis NPS 650 User Manual

Network Installation

Before you begin:
Notes:
Axis NPS 650 User's Manual
• Make sure that your network is ready to accept a new node.
• Any network configuration should always involve the network
manager.
• Don't connect or disconnect the network cabling, or change the
Ring Speed setting while the NPS 650 is powered on.
1. Switch off the printer and disconnect the external power supply.
2. Record the serial number of your NPS 650. You will need this
number for the setup.
3. Slide the RING SPEED switch towards 4 or 16 depending on the
ring speed of your network.
4. Connect your NPS 650 to the network using a STP (Media Type 1)
or UTP (Media Type 3) Token Ring cable.
5. Switch on the printer and connect the external power supply.
It is not recommended to use standard UTP cabling on 16 Mbit
networks, but screened or foiled Media Type 3 cabling may be used.
Each NPS print server is preconfigured with a unique Node Address
(identical to the serial number). You can change this to a Locally
Administrated Address, see page 65.
The installation is now completed. Proceed with the setup sections for
NetWare, Windows, OS/2 and/or Unix.
Section 2: Getting started
13