Axis NPS 650 User Manual page 27

Configure the
NPS 650
Axis NPS 650 User's Manual
The configuration involves specifying which NetWare print servers and
printer numbers the NPS 650 shall attach to. This is done using AXCFG,
the Axis NPS installation software on the disk supplied with the NPS
650. Follow the instructions in the read.me file on the disk to install the
software, then proceed as follows:
1. Start AXCFG, and select NetWare.
2. Select No at the 'Look for old print servers' prompt.
3. Choose Select All Networks, then select your NPS 650.
4. Type root and pass at the login prompt.
5. Select NETWARE MENU.
6. Select RPRINT1.
7. Type the name of the NetWare print server and the printer number
(4.xx: Use printer numbers 1 and higher). Use the name and number
from the NetWare configuration earlier.
Example: Use printer 0 at BILBO_NLM as remote printer
8. To specify more print servers, select RPRINT2 through RPRINT8
in consecutive order. Repeat step 7 for each print server.
9. Select Save, then select Cancel until AXCFG closes down.
Section 3: Setup for NetWare
27