LPT1 Printer Connector Parallel COM1 Printer connector Serial 1. Record your NPS 550 serial number (you will need it during the configuration). 2. Switch off the printer. 3. Connect your printer to the NPS 550 LPT1 port using the supplied printer cable.
Page 3
NetWare The procedure below applies to the NPS 550 Print Server Mode only and is recommended only if you have a small network with just a few file servers. If you prefer to use the Remote Printer Mode or if you have a larger network, see the NPS 550 User’s Manual.
1. Double-click the Axis Print Utility. 2. In the Port menu, click Add. 3. In the NPS Port list, select the NPS 550 port you want to install. The ports appear as <name>.LP1, <name>.LP2 and <name>.CM1, where <name> is the NPS 550 print server name...
Page 5
1. Double-click the Axis Print Utility. 2. In the Port menu, click Add. 3. In the NPS Port list, select the NPS 550 port you want to install. The ports appear as <name>.LP1, <name>.LP2 and <name>.CM1, where <name> is the NPS 550 print server name (AXIS...
1. Double-click the Axis Print Utility. 2. In the Port menu, click Add. 3. In the NPS Port list, select the NPS 550 port you want to install. The ports appear as <name>.LP1, <name>.LP2 and <name>.CM1, where <name> is the NPS 550 print server name (AXIS...
Page 7
2. When Axis Print Utility is running, click Install to install your NPS 550. It will then appear in the print server list as AX<nnnnnn>.LP1, AX<nnnnnn>.LP2 and AX<nnnnnn>.CM1 (<nnnnnn> are the last six digits of your NPS 550 serial number).
Page 8
2. If your network has more than one zone, click the name of the default zone. Click the name of the printer you want. The default NPS 550 printer names are AXIS<nnnnnn>_<port> (<nnnnnn> is the last six digits of the NPS 550 serial number, and <port> is LPT1, LPT2 or COM1).
Page 9
1. Find an unused Internet address (IP address) and choose a unique host name for your NPS 550. 2. Add the NPS 550 IP address and host name to your system host table by appending the following line to the /etc/hosts file: <IP address>...