Axis NPS 650 User Manual page 25

NetWare 3.xx:
Notes:
Axis NPS 650 User's Manual
1. Select Print Server Information from the PCONSOLE Main Menu.
2. Select the NetWare Print Server to which you want to link your
NPS 650.
3. Select Print Server Configuration, and then Printer Configuration.
4. Select the first free slot in the Configured Printers list.
5. Make a note of the NetWare print server name and the Printer
number; you will need it later during the configuration.
6. Change Name to AXIS<nnnnnn>!n
nnnnnn> are the last six digits of the NPS 650 serial number.
<
7. Change Type to Remote Other/Unknown.
8. Press <Esc>, and select Yes at the Save Changes prompt.
9. Select Queues Serviced by Printer in the Print Server Configuration
Menu.
10.Select AXIS<nnnnnn>!n in the Defined Printers list.
11.Press <Insert>, then select the queue you want to use from the Avail-
able Queues list. Repeat this step if you want more than one queue.
12.Press <Esc> to get back to the Main Menu, then exit PCONSOLE.
Repeat this procedure for each file server and print server using the NPS
650.
1. If the serial number of your NPS 650 is 000231480061, then the
default name is AXIS480061. The serial number is found on the label
at the back of the NPS 650.
2. You may change the default name using AXCFG, the Axis Configura-
tion Software. This must be done before running PCONSOLE.
3. You may define up to eight remote printers, each attached to its own
NPS 650 logical printer. Each remote printer must have a unique
name distinguished by the !n extension.
Section 3: Setup for NetWare
(see notes below)
25