Transmitting The Memory Data; Transmitting The Measurement Data - A&D UA-767NFC Instruction Manual

Transmitting the Memory Data

While the device displays the clock, hold the communication symbol of the
NFC-enabled communication device close to the communication area (
device until "
clock of the device is not correct, the clock will be updated at the same time.
Initiate
communication
Initiate
communication
Clock display

Transmitting the Measurement Data

When the measurement is complete and the device displays the results, hold the
communication symbol of the NFC-enabled communication device close to the
communication area (
performed. If the clock of the device is not correct, the clock will be updated at the
same time.
Initiate
communication
Measurement
data display
Note: The result display will turn off automatically after one minute. To transmit the
measurement data, initiate the communication within one minute after the
measurement is complete.
Caution on Using the NFC Function
The UA-767NFC has an NFC Forum Type 3 Tag wireless interface module built
in. When the device is used near wireless communication devices which use the
same frequency as that of the device (13.56 MHz) or use its harmonic
frequencies, electromagnetic interference may occur. In that case, turn off the
devices that are not in use, or place the device 1 meter or more away from the
devices.
" appears. The memory data transmission is performed. If the
Transmission starts
) of the device until "
Transmission starts
Number of data in memory
Data
transmission
Data
transmission
Transmission ends
" appears. The data transmission is
Data
transmission
Transmission ends
English 17
) of the
Clock updated
Clock display
Clock display