Notes On The Built-In Clock - A&D UA-767NFC Instruction Manual

Notes on the Built-in Clock

The device displays the clock as long as power is connected.
Adjust the clock prior to use.
During measurement, the clock adjustment is not available.
When adjusting the clock, press the
press and hold the
The setting procedure cannot be reversed. If the wrong value is set, start the
setting procedure again.
The current clock setting will be cleared if the batteries are removed, or power is
not connected for approximately 30 seconds while the AC adapter is used. In this
case, adjust the clock again.
If the clock is set and you want to manually adjust the time:
Press and hold the
You can cancel the settings by pressing the
return to the clock display mode.
After 30 seconds of non-operation, the setting procedure will be automatically
canceled and the screen will return to the clock display mode.
When inserting, exchanging the batteries or connecting the AC adapter:
"Year" blinks automatically and the screen will go to clock settings.
To start measurement, set the clock as described on page 8.
Pressing the
complete clock settings first.
After 30 seconds of non-operation, the setting procedure will be automatically
canceled and the screen will display 0:00. (Clock setting is not completed and
measurement cannot start.)
When exchanging the batteries or reconnecting the AC adapter, the screen
displays Year, month, and date last time the batteries or AC adapter was
removed. You need to complete the setting of actual date and clock before use.
button to change the value continuously.
button to go to clock settings.
button will not return to the clock display mode. You must
START
button to increase the value by one, or
START
English 9
button and the screen will