Redundant Hot-Plug Power Supply Option - HP ProLiant DL380p Gen8 User Manual

Connect the power and data cable to the system board and the optical drive.
7.
Install the access panel (on page 25).
8.
Install the server into the rack
9.
Connect each power cord to the server.
10.
Connect each power cord to the power source.
11.
Power up the server (on page 23).
12.

Redundant hot-plug power supply option

CAUTION:
Verify that all power supplies have the same part number and label color. The system becomes
unstable and may shut down when it detects mismatched power supplies.
Label color
Blue
Orange
White
Green
CAUTION:
all bays are populated with either a component or a blank.
To install the component:
Access the product rear panel (on page 25).
1.
Remove the blank.
2.
WARNING:
power supply blank to cool before touching it.
("Installing the server into the
All power supplies installed in the server must have the same output power capacity.
Output
460W
750W
750W 48V DC
1,200W
To prevent improper cooling and thermal damage, do not operate the server unless
To reduce the risk of personal injury from hot surfaces, allow the power supply or
rack" on page 38).
Hardware options installation 65