Memory Configurations - HP ProLiant DL380p Gen8 User Manual

Item Description
Voltage rating
4
Memory speed
5
DIMM type
6
For the latest supported memory information, see the QuickSpecs on the HP website
(http://h18000.www1.hp.com/products/quickspecs/ProductBulletin.html). At the website, choose the
geographic region, and then locate the product by name or product category.

Memory configurations

To optimize server availability, the server supports the following AMP modes:
•
Advanced ECC—provides up to 4-bit error correction and enhanced performance over Lockstep mode.
This mode is the default option for this server.
•
Online spare memory—provides protection against failing or degraded DIMMs. Certain memory is
reserved as spare, and automatic failover to spare memory occurs when the system detects a DIMM that
is degrading. This allows DIMMs that have a higher probability of receiving an uncorrectable memory
error (which would result in system downtime) to be removed from operation.
Advanced Memory Protection options are configured in RBSU. If the requested AMP mode is not supported
by the installed DIMM configuration, the server boots in Advanced ECC mode. For more information, see
"HP ROM-Based Setup Utility (on page 104)."
The server also can operate in independent channel mode or combined channel mode (lockstep). When
running in lockstep mode, you gain reliability in one of two ways:
•
If running with UDIMMs (built with x8 DRAM devices), the system can survive a complete DRAM failure
(SDDC). In independent channel mode, this failure would be an uncorrectable error.
•
If running with RDIMM (built with x4 DRAM devices), the system can survive the complete failure of two
DRAM devices (DDDC). Running in independent mode, the server can only survive the complete failure
of a single DRAM device (SDDC).
Maximum capacity
DIMM type
RDIMM
RDIMM
LRDIMM
UDIMM
UDIMM
HDIMM
For the latest memory configuration information, see the QuickSpecs on the HP website
(http://www.hp.com).
Definition
L = Low voltage (1.35v)
U = Ultra low voltage (1.25v)
Blank or omitted = Standard
12800 = 1600-MT/s
10600 = 1333-MT/s
8500 = 1066-MT/s
R = RDIMM (registered)
E = UDIMM (unbuffered with ECC)
L = LRDIMM (load reduced)
H = HDIMM (HyperCloud)
DIMM rank One processor
Single-rank 96 GB
Dual-rank 192 GB
Quad-rank 384 GB
Single-rank 32 GB
Dual-rank 64 GB
Dual-rank 192 GB
Two processors
192 GB
384 GB
768 GB
64 GB
128 GB
384 GB
Hardware options installation 52