Sewing preparation
14
Winding a bobbin
turn power switch to «I»
█
place empty bobbin on spindle
█
place foam pad on the spool pin
█
place thread on the spool pin
█
attach appropriate spool disc
█
following the direction of the arrow, take thread through the rear guide and
█
round the pre-tension stud
a
wind the thread two to three times around the empty bobbin
█
cut off any excess thread on the thread cutter a
█
appropriate spool disc
Diameter of thread spool determines disc size, there must be no gap
between the disc and the spool.
push engaging lever a against bobbin
█
►
the winder works automatically
►
the motor will stop automatically when the bobbin is full
remove bobbin and
█
pull the thread over thread cutter a to cut it
a
█
B
Bobbin winding while sewing
attach foam pad on the vertical spool pin B
█
place thread on the vertical spool pin
█
following the direction of the arrow, take thread through the thread guide c
c
█
and
guide around the pre-tension stud
█
Then proceed as mentioned above.
033471.52.04_2014-02_Manual_B530_550_EN