Changing The Presser Foot; Stitch Plate - Bernina 530 User Manual

changing the presser foot

Stitch plate

remove presser foot
raise the needle and presser foot
█
turn power switch to «0» (off)
█
raise the clamping lever
█
remove the presser foot
█
attaching the presser foot
guide the foot upwards over the cone
█
press the clamping lever down
█
Stitch plate markings
a
̶ the stitch plate is marked with vertical, horizontal and diagonal lines in mm
and inches
̶ the lines help to guide the fabric for sewing seams and precise
topstitching, etc.
̶ the horizontal markings are helpful for sewing corners and buttonholes, etc.
̶ the diagonal markings are useful for quilting
̶ needle insertion point is position «0» (center needle position)
̶ the vertical measurements correspond to the distance between the needle
and the line
B
̶ the measurements are marked to the right and left, measuring from the
center needle position
remove the stitch plate
press «Feed dog»-button (see page 11)
█
►
the feed dog is lowered
turn power switch to «0» (off)
█
remove presser foot and needle
█
press the stitch plate down at the right back corner a until it flips up
█
remove the stitch plate
█
replace the stitch plate
place the stitch plate over the opening B
█
press down until it clicks into place
█
press «Feed dog»-button
█
►
the feed dog is raised as soon as the first stitch is sewn
033471.52.04_2014-02_Manual_B530_550_EN
Sewing preparation
19