The Hob - Zanussi ZCG563 User Manual

The hob

The gas hob has different burner sizes to suit
different types of cooking.
To ensure maximum burner efficiency only use pots
and pans with flat bases appropriate to the burner
size used.
Using the hob
To light the hob burners
The hob ignition works by means of a battery. Lift up
the lid. You can not use the hob when the lid is down.
After this time release the controls. The flame should
remain alight. If after 10 seconds the burner has not
lit, stop operating the appliance and wait at least 1
minute before attempting a further ignition of the
burner. When the burner has lit release the control
and ignition button, adjust the setting as required.
!
WARNING!
In the event of the burner flame being accidentally
extinguished, turn off the burner control and do not
attempt to re-ignite the burner for at least 1 minute.
8
Push in and hold the
control knob, turn to the
large flame symbol
(highest setting).
Press the ignition button
immediately. Keep the
control knob depressed
for up to 5 seconds, but no
longer than 10 seconds.
!
WARNING!
After the ignition, check the flames visually. If you see
yellow tip, lifted or unstable flames; turn the gas flow
off, and check the assembly of burner caps and
crowns. Also, make sure that no liquid has flown into
the burner cups. If the burner flame goes out
accidentally, turn the burner off, ventilate the kitchen
with fresh air, and do not attempt re-ignition for 90
sec.
Cap
Crown
Spark
Plug
Burner
Cup
!
WARNING!
Ensure the pan supports are correctly fitted before
using the hob.
!
WARNING!
If the ignition button is not pressed immediately a
build up of gas may cause the flame to spread.
Pans
To get the best efficiency from your appliance and for
your safety, use the following pan sizes for each
burner.
To turn off any burner
Rapid Burner: 22-26 cm
Medium Burner: 14-22 cm
Auxillary Burner: 12-18 cm