Levelling The Appliance; Connecting To Gas Supply - Zanussi ZCG563 User Manual

• For appliances installed in the Republic of Ireland
please refer to NSAI-Domestic Gas Installation
IS813 Current Edition Section7 Permitted Locations
of appliance Table4— Locations and Permanent
Ventilation requirements-flueless appliances. Note:
- L.P.G. cookers MUST NOT be installed below
ground level i.e. in a basement or aboard any boat,
yacht or other vessel.

Levelling the appliance

• Adjustment to suit floor conditions or height is
obtained by rotating clockwise or anti clockwise the
feet at the front and rear of the appliance. A spirit
level should be placed on one of the shelves to
confirm the appliance is correctly levelled.

Connecting to gas supply

• This appliance is designed to be installed with an
appliance flexible connection only.
• Supply piping should not be less than R3/8.
Connection is made to the Rc ½ (½" B.S.P)
female threaded entry pipe located just below
the hob level on the rear right hand side of the
appliance.
22
min 150
min 7
min 1
IMPORTANT!
Only liquid sealants to be used when inlet gas pipe is
• Carry out a gas tightness test after connecting to
• The gas bayonet connector must be fitted in the
• Take into account that it must be possible to pull
Flexible tubing used must comply with BS. 669
current edition.
LPG Flexible connections must be a type suitable
for L.P.G and capable of operation up to 50 mbar
and carry a red stripe, band or label.
Fixing the stability chain
To further prevent tilting and for safe usage of the
appliance a stability chain should be used. Unscrew
the screw shown in the figure. Then, align the first
loop of the chain with the hole and assemble with the
screw so that the chain stands in its place safely.
Check the assembly by gently pulling the chain from
its loose end. Fix the loose end to the rear wall as
appropriate for your kitchen. The chain is not supplied
within the package of the appliance, but can easily be
supplied from the market.
fitted i.e.: do not use P.T.F.E. sealant tape.
the gas supply.
enlarged area indicated.
the appliance forward sufficiently. Ensure the hose
does not become trapped when pushing the
appliance into position.
Gas Inlet