Power Supply Cable - CognitiveTPG A798 User Manual

18 Chapter 3: Setting up the Printer

Power supply cable

To avoid damaging the printer, connect the power supply last.
1 Plug the power cable into the power connector located in the center of the illustration.
2 Close the connector cover until it snaps, making sure that all the cables are aligned with the slots in the connector cover.
Double-check that the strain relief on the connector cover is aligned with the power supply cable (see "Cable routing"
section which follows).
3 Plug the power cord into the power supply.
4 Plug the power supply into a grounded outlet. When it is properly powered, the green LED on the top of the printer will
light up.
WARNING! Using this device without a grounded outlet is a safety hazard and voids the printer Warranty, Safety, FCC
and CE Mark designation.
A798 Thermal Receipt Printer: User Guide A798 Thermal Receipt Printer: User Guide
Connector Interface Panel
Power
Supply
Connector
A798-UG00001 Rev. A A798-UG00001 Rev. A 10/07 10/07