U-Wrap Lounger Seating - Four winns FREEDOM Owner's Manual

The engine hatch can be lifted without the screw
jack(s). Use care and proper lifting techniques
to prevent possible back injury. Prop rod must
be properly placed to keep engine hatch in open
position when lifting manually.
3. Place the prop rod into the prop rod holders in the
hatch and lower the hatch so the prop rod supports
the hatch. Note: Ensure you lower the screw jack(s)
to allow the engine hatch to rest on the rod.
Always use the engine hatch's prop rod when
working on the engine. This provides added
safety while helping to prolong the life of the
screw jack(s) and engine hatch.
NOTICE
Never operate or trailer your boat with the en-
gine hatch in its open position. Doing so could
result in damage to the engine hatch, hardware,
and/or loss of cushions.
To lower the engine hatch:
1. Raise the hatch slightly and remove the prop
rod from its holder.
2. Press the engine hatch switch or manually
lower the engine hatch to its closed position. If
closing the engine hatch manually, gently lower
it to the deck. Do not allow it to just drop to the
deck.
3. Replace and secure the backrest walk-thru
door and the walk-thru fill-in cushion (if appli-
cable).
If closing the engine hatch manually, do not
allow the engine hatch to "slam" shut. Allow-
ing the engine hatch to "slam" shut can dam-
age the fiberglass and/or cause bodily injury.
NOTICE
Cushions, if not properly stored and secured,
can blow out of the boat.
Freedom™/Horizon™ Owner's Manual
O. U-Wrap Lounger Seating
U-wrap (shaped) seating is found in certain Horizon™
models. A large amount of storage space is located
under the removable seat cushion. These Horizon™
models usually have a 36-quart removable cooler lo-
cated under the hinged seat cushion. See Figures N19,
N20 & N21.
Figure N19: U-Wrap Aft Seating
Note: Representative View - Seating may vary depending upon model.
Figure N20: Underseat Storage
Removable Cooler
Figure N21: 36-Quart Cooler Storage
Section N
Page 8