Head Pump Out - Four winns FREEDOM Owner's Manual

NOTICE
The Vacu-Flush switch located in the head must
be ON in order for the toilet to flush & recharge.
To operate:
1. To add water to the toilet before using, raise flush
lever until desired water level is reached. Gener-
ally, more water is required only when flushing sol-
ids. See Figure J11.
2. To flush toilet, press flush lever sharply down to the
floor until contents clear bowl. A sharp popping noise
is normal when the vacuum seal is broken and the
flushing action begins. Be sure to hold lever down
for 3 seconds. If flush lever is accidentally released
before waste clears bowl, do not attempt to flush
toilet again until vacuum pump stops running. A
small amount of water should remain in the bowl
after flushing.
3. Do not dispose of sanitary napkins or other non-
dissolving items in toilet, such as facial tissue or
paper towels. These items can cause plugging of
the system. Refer to the "Deodorants and Special
Tissue" section in the manufacturer's manual for
more information.
2.
1. Add
3 Seconds
Water
Lift
Figure J11: Vacu-flush™ Operations
Figure J12: Vacu-flush™ Vacuum Generator
Freedom™/Horizon™ Owner's Manual
3. Do Not
Flush For
Press
D. Head Pump Out
The waste holding tank should be emptied when waste
holding tank level gauge indicator on the porta potti (mod-
els with pumpout option only) has changed from green
to red (Figure J13) or when the waste level indicator for
the Vacu-flush system reads almost full. DO NOT AL-
LOW THE TANK TO BECOME OVERFILLED.
Figure J13: Porta Potti
If equipped with the head pump out, the waste can be
removed from the tank at a pumping station. A deck plate
fitting labeled WASTE, is provided for this purpose. Most
marina fueling facilities provide service for waste pump
out. For waste holding capacities, please refer to the
specification sheet, manufacturer's literature and/or our
website.
To pump out the holding tank:
1. Connect the dockside pump out connection to the
WASTE plate located on the deck.
NOTICE
Usually the dockside pump out connection will
screw into the waste deck plate or has a rubber
sleeve that inserts into the plate and must be
held in position during the pump out operation.
2. Have the pumping station operator activate the pump-
ing equipment. The waste will be drawn from the
holding tank and into the pumping stations disposal
tank.
3. Remove the pump out connection from the deck plate.
Add 1 gallon of clean water to the holding tank through
the waste deck fitting using a dockside water hose.
4. Repeat steps 1 & 2 above to pump out the water
used in step 3 to flush the holding tank.
5. Add waste holding tank treatment chemical available
from the dockside pumping station operator to the
head. Flush at least twice.
Section J
Page 5