Center Cockpit Cushion; C-Wrap Aft Lounger Seating; Port Lounger - Settee; Exterior Upholstery Care - Four winns FREEDOM Owner's Manual

4) Repeat this procedure for the other sun lounge
if required.
5) Insert fill-in backrest and fill-in cushion if appli-
cable. Store any cushions not being used to
prevent loss or damage.
S. Center Cockpit Cushion -
The center cockpit cushion is installed on the engine
hatch and provides comfortable seating for your pas-
sengers. By simply lifting up and out on the center cock-
pit cushion, minimum access can be gained to the en-
gine compartment for quick inspections.
T. C-Wrap Aft Lounger Seating
Standard on certain models is an aft C-wrap style seat-
ing configuration. See Figure N38. Storage and cooler
access can be gained by lifting up the various cush-
ions. Use of both hands when lifting up on a cushion
will make for an easier operation. Also, quick inspec-
tion access to the engine compartment can be gained
by lifting up and out on the center cockpit cushion.
Figure N38: Aft C-Wrap Lounger Seating
U. Port Lounger - Settee
A cozy settee lounger is provided on portside, in front
of the cockpit refreshment center, on certain Horizon™
models. See Figure N39. The settee not only provides
a comfortable and elegant seating arrangement but of-
fers additional storage space underneath. To gain ac-
cess to the storage below, lift up on the settee cushion
and pull out.
Freedom™/Horizon™ Owner's Manual
(Certain Models Only)
N - 2
A. Cleaning Vinyl
The vinyl material used on the exterior upholstery should
be cleaned regularly with warm water and a mild dish
soap or Vinyl Finish Vinyl Cleaner® using a soft clean
cloth, then rinse with a soft clean cloth. For dirt buildup,
spray Vinyl Finish Vinyl Cleaner®, let soak for approxi-
mately ten (10) minutes, then gently scrub with a soft
bristle brush. Be sure to thoroughly rinse the vinyl after
washing with mild dish soap or Vinyl Finish Vinyl
Cleaner® to remove all residue. Towel dry the vinyl.
Periodic spraying of the seats with Lysol Spray Disinfec-
tant™ will help retard mildew.
To further protect the vinyl from early degradation, use
303 Aerospace Vinyl Protectant®. Spray on, then wipe
dry. 303 Vinyl Protectant should be applied every 3-5
weeks when boat is in use. Regular cleaning with mild
soap and water or Vinyl Finish Cleaner will not remove
the 303.
Figure N39: Port Settee Lounger

EXTERIOR UPHOLSTERY CARE

NOTICE
Vinyl upholstery should be cleaned and main-
tained in accordance with the manufacturer's
recommendations and instructions.
NOTICE
DO NOT apply vinyl protectants such as
Armorall®. The manufacturer does not recom-
mend this product because it removes the oils
present in vinyl that keeps vinyl soft.
Section N
Page 13