Table of Contents
Advertisement
Figure N11: Aft Cockpit Stern Seat w/ Hinge Assembly
C. Port Helm Lounger
The port helm lounger provides seating capacity for two
people and is positioned to permit conversations with
those seated at the helm or stern. It is fastened to a
fiberglass base. See Figure N12.
Port Helm Lounger
Figure N12: Cockpit Overhead View
D. Cockpit Table
The aft cockpit table is standard on the 378. Table bases
are "flush" mounted for convenience. The cockpit table
and 32" leg is be stored underneath the starboard cock-
pit seat. Note: The cockpit table is also used as the fill-
in cushion support using the 17" leg. See Section N2-B
for installation and removal of cockpit fill-in cushion.
378 Vista™ Owner's Manual
378
Hydraulic
Extended
Hinge
Folded
To set up the cockpit table:
1. Raise the starboard cockpit seat up to gain access
to the 32" (Iong) table leg and cockpit table. Re-
move table and leg from storage compartment.
2. Insert 32" leg into floor mount.
3. Place folded cockpit table (mount) onto the leg.
4. Unfold cockpit table, be sure to utilize the "dog bone"
sliding supports. Simply slide "dog bone" sliding
supports into support positions. See Figure N13.
To remove the cockpit table simply reverse the proce-
dure above.
To prevent damage to cockpit table and/or cock-
pit interior ensure the cockpit table and legs are
properly stored.
E. Deck Sunpads
These sunpads are optional. These cushions securely
snap in place and provide comfort while sunbathing on
the foredeck. See Figure N14.
™
"Dog Bone" Slide Assembly
Figure N13: Cockpit/Fill-In Table
NOTICE
Section N
Page 4
Advertisement
Table of Contents
