Table of Contents
Advertisement
2. Position the seat according to the needs of the driver
by lifting up on the release handle under the middle
of the seat. See Figure N6.
3. Tilt the steering wheel to the desired position using
the tilt lever knob on the steering column.
To rotate the port (passenger) bucket seat to face aft:
1. Slide the seat completely forward by lifting up on
the release handle under the middle of the seat. See
Figure N6.
2. Locate the lever on the left side of the slider mecha-
nism and pull to release the pin from the pedestal.
This will allow you to rotate the seat. See Figure
N6.
3. Rotate the bucket seat clockwise (inboard) until it
faces the desired aft position. DO NOT USE FORCE
to rotate the chair.
NOTICE
When rotating the port side bucket, damage to
seat and/or coaming pad may result if attempt-
ing to rotate in the wrong direction, or over-ro-
tating, and/or with the seat not fully forward. .
DO NOT USE FORCE to rotate the chair.
To return the port (passenger) bucket seat to the bow
facing position:
1. Rotate the bucket seat counterclockwise (outboard)
until the seat mechanism locks into place. In addi-
tion, DO NOT USE FORCE to rotate the chair.
NOTICE
When rotating the port side bucket, damage to
seat and/or coaming pad may result if attempt-
ing to rotate in the wrong direction, or over-ro-
tating, and/or with the seat not fully forward. .
DO NOT USE FORCE to rotate the chair.
2. Position the seat according to the needs of the indi-
vidual by lifting up on the release handle under the
middle of the seat. See Figure N6.
DO NOT sit on the backrest portion of any cock-
pit seat. The helmsman could lose control of
boat or passengers could be thrown from boat.
Also, the seat may be damaged from improper
use.
Candia FS Owner's Manual
03/00
F. L-Shaped Lounger Seating
L-shaped seating is found in all Candia FS models.
Large amounts of storage space is located under ei-
ther the removeable seat cushions (214) or the hinged
seat cushions (234/254). To assist you when placing
or removing items from the storage compartments hy-
draulic lifts have been provided on the 234/254 Candia
FS models.
G. Motorbox (Engine Covers)
The motorbox is incorporated in the L-shaped seating
arrangement. To gain access to the engine follow the
instructions below for the different models.
1. 214 Candia FS:
a. Lift up on the top storage cushion strap and move
the cushion up and back out of the way. This cush-
ion is attached by hinges which prevent the cush-
ion from being lost overboard. This step alone will
allow you limited access to the engine compart-
ment.
b. To gain greater access to engine compartment,
undue the white shock cord (bungie cord) from
the knob.
c. Lift the motorhood upward by placing your hands
underneath the middle of the motorhood backrest.
Lift evenly. Two gas shocks will assist in raising
the motorhood and holding it in place will work is
being performed.
To lower the motorhood, simply reverse the process.
NOTICE
Ensure to place the shock cord strap around
the knob before operating. Also ensure the
top storage cushion is properly seated. This
will prevent damage to motorhood and/or top
storage cushion while underway.
2. 234/254 Candia FS:
a. Release the motorhood locking lever by pushing
in on the button on the lever itself. Make sure to
open the locking lever completely.
b. Once the locking lever is released, place your fin-
gers inside the detent of the locking lever, and pull
the motorhood forward, gently, until it rest on the
cockpit floor. The motorhood is hinged which
makes the opening and closing easy.
Section N
Page 4
Advertisement
Table of Contents
