Setting The Configuration Register While Running Cisco Ios; Setting The Configuration Register While Running Rom Monitor - Cisco 7401ASR Installation And Configuration Manual

Setting the Configuration Register While Running Cisco IOS

If the prompt is "rommon1", the confreg command displays the virtual configuration register currently
in effect. It includes a description of the bits. See the following sample output:
Setting the Configuration Register While Running Cisco IOS
The configuration register can be set in the configuration mode with the config-register 0x<value>
command. See the following sample output:

Setting the Configuration Register While Running ROM Monitor

If the prompt is ">", the or0x<value> command sets the configuration register. See the following sample
output:
If the prompt is "rommon1", the confreg command sets the configuration register. It prompts the user
about each bit. See the following sample output:
Cisco 7401ASR Installation and Configuration Guide
D-6
14 IP broadcasts do not have network numbers
13 Boot default ROM software if network boot fails
12-11 Console speed is 9600 baud
10 IP broadcasts with ones
09 Do not use secondary bootstrap
08 Break disabled
07 OEM disabled
06 Ignore configuration disabled
05 Fast boot disabled
04 Fan boot disabled
03-00 Boot to ROM monitor
rommon 1 > confreg
Configuration Summary
enabled are:
load rom after netboot fails
console baud: 9600
boot: the ROM Monitor
Do you wish to change the configuration? y/n
Router# config t
Enter configuration commands, one per line. End with CNTRL/Z.
Router(config)#config-register 0x2142
Router(config)#end
Router#
%SYS-5-CONFIG_I: Configured from console by console
>o/r 0x2102
>
rommon 1 > confreg
Confiuration Summary
enabled are:
load rom after netboot fails
console baud: 9600
boot: the ROM Monitor
do you wish to change the configuration y/n
enable "diagnostic mode"? y/n
Appendix D
[n]
[n]: y
[n]: n
Configuration Register Information
OL-5419-01 B0