Cisco 7401ASR Installation And Configuration Manual page 74

Configuring a Cisco 7401ASR Router
For the following queries, enable routing on AppleTalk and IPX:
Step 7
Configure AppleTalk? [no]: yes
Multizone networks? [no]: yes
Configure IPX? [no]: yes
In most cases you use IP routing. If you are using IP routing, you must also select an interior routing
Step 8
protocol. You can specify only one of two interior routing protocols to operate on your system using the
setup facility: Interior Gateway Routing Protocol (IGRP) or Routing Information Protocol (RIP).
To configure IP routing, enter yes (the default) or press Return, and then select an interior routing
protocol:
Configure IP? [yes]:
Configure IGRP routing? [yes]:
Your IGRP autonomous system number [1]: 15
The following sample display includes a continuous listing of all configuration parameters selected in
Step 3
Configuring global parameters:
Enter host name [Router]: router
The enable secret is a one-way cryptographic secret used
instead of the enable password when it exists.
Enter enable secret: barney
The enable password is used when there is no enable secret
and when using older software and some boot images.
Enter enable password: betty
Enter virtual terminal password: fred
Configure SNMP Network Management? [yes]:
Community string [public]:
Configure Vines? [no]:
Configure LAT? [no]:
Configure AppleTalk? [no]: yes
Multizone networks? [no]: yes
Configure DECnet? [no]:
Configure IP? [yes]:
Configure IGRP routing? [yes]:
Your IGRP autonomous system number [1]: 15
Configure RIP routing? [no]:
Configure CLNS? [no]: n
Configure bridging? [no]:
Configure IPX? [no]: yes
Configure XNS? [no]:
Configure Apollo? [no]:
Save your settings to NVRAM. (See the
Step 9
page 3-21.) If you do not save the configuration settings you created in the router using configuration
mode and the setup facility, your configuration will be lost th enext time yuou load the router.
Cisco 7401ASR Installation and Configuration Guide
3-14
through Step 8. Only IP, IPX, and AppleTalk are the selected protocols for this example.
"Saving the Running Configuration to NVRAM" section on
Chapter 3 Starting and Configuring
OL-5419-01 B0