Installing The Cable Management Assemblies - Cisco Nexus 7000 Series Hardware Installation And Reference Manual

Chapter 3 Installing a Cisco Nexus 7018 Chassis

Installing the Cable Management Assemblies

S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
Figure 3-7 ESD Grounding Ports on the Front of the Cisco Nexus 7018 Chassis
1
1 ESD port

Installing the Cable Management Assemblies

After you have fully installed the Cisco Nexus 7018 device chassis in the rack or cabinet (see the
"Installing the Chassis" section on page 3-6), you can install the cable management assemblies on the
front of the chassis.
To install the cable management assemblies on the Cisco Nexus 7018 device chassis, follow these steps:
Step 1 Attach a lower cable management assembly (800-31343-01) onto the two hooks that protrude from the
lower half of the left rack-mount bracket that is attached to the Cisco Nexus 7018 device chassis, and
loosely fasten the assembly to the chassis with four flat-head M4x10 screws as shown in Figure 3-8.
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
3-14
OL-18634-01