Cisco Nexus 7000 Series Hardware Installation And Reference Manual page 78

Installing the Front Door and Air Intake Frame
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
Figure 3-21
1 Door handle pulled out until it clicks
3 Hinge pins
Step 14 Swing the door closed so that the unused hinge pins fit inside the slots on the top and bottom of the door.
When you close the door, the door stopper automatically presses the lock button on the inside of the door
so that the door is locked on the hinge pins. If the door stopper does not close the latches, press the door
closed at the handle until you hear the latches click. Make sure that the door is fully secured to the frames
on both sides.
If a hinge pin is not secured behind a door latch, open the door handle for that side of the door until it
Note
clicks, open that side of the door, and then press the door closed so that the pins are positioned all the
way inside the door slots. When you close the door, the door stopper automatically closes the door
latches. If you do not hear the latches click, press the door at the handle to fully close it and to activate
the latches. Test the door to make sure that it is fully secured to the four hinge pins.
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
3-28
Attaching the Right Side of the Door
3
4
2
1
2
4
3
Chapter 3 Installing a Cisco Nexus 7018 Chassis
2 Swing the door closed
4 Slots for hinge pins
OL-18634-01