Cisco Nexus 7000 Series Hardware Installation And Reference Manual page 156

Replacing a CompactFlash Card
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
If the card does not fit easily into the slot, flip the card so the bottom edge is on top, and try pushing the
card into the slot.
Step 7 Wait for the reader LED to turn green and for a message to appear on the console.
If you are installing a card into the log flash reader, the message will end with "logflash:online."
•
switch# 2008 Mar 15 08:00:00 switch %$ VDC-1 %$ %IDEHSD-2-MOUNT: logflash:online
If you are installing a card into the expansion flash reader, the message will end with "slot0:online."
•
switch# 2008 Mar 15 08:00:00 switch %$ VDC-1 %$ %IDEHSD-2-MOUNT: slot0:online
If you see an offline message or do not see a message, either the card is not fully pushed into the
•
reader or it is improperly formatted.
switch# 2008 Dec 1 12:00:00 switch %$ VDC-1 %$ %IDEHSD-2-UMOUNT:logflash:offline
Make sure that the card is fully inserted inside the reader. If the card is fully inserted, either format
the card (see the Cisco NX-OS Fundamentals Configuration Guide, Release 4.0) or replace the card
with another card that is properly formatted for the reader.
Step 8 Remove the bottom frame assembly by completely unscrewing the four screws identified in
Figure 8-5
Remove the front doors on the middle of the frame by unscrewing the six screws (three on each side)
Step 9
identified in
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
8-16
Removing the Bottom Frame
Figure 8-6.
Chapter 8 Removal and Installation Procedures
Figure 8-5.
OL-18634-01