Replacing A Cisco Nexus 7010 System Fan Tray During System Operations; Required Tools; Replacing A Cisco Nexus 7010 System Fan Tray - Cisco Nexus 7000 Series Hardware Installation And Reference Manual

Chapter 8 Removal and Installation Procedures
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
Step 12 With one hand holding each side of the module, align the backside of the module to the slot guides in
the vacated slot, and slide the module part way into the slot.
To prevent ESD damage, avoid touching the electronic circuitry and prevent anything else from coming
Caution
in contact with the circuitry.
With one or both hands on the face of the module, push the module all the way into the slot until it seats
Step 13
on the midplane connector. The EMI gasket will close the gap between this module and any module or
chassis edge that is immediately above the module that you just installed.
Simultaneously push both ejector levers inward until they come in contact with the face of the module.
Step 14
The captive screws should be aligned to their holes in the chassis.
Tighten the two captive screws on the fabric module to 69 N m (8 in-lb).
Step 15
Replacing a Cisco Nexus 7010 System Fan Tray During System
Operations
The Cisco Nexus 7010 system has two system fan trays located on the upper backside of the chassis (see
Figure 1-3 on page
Hazardous voltage or energy is present on the backplane when the system is operating. Use caution
Warning
when servicing. Statement 1034
For instructions on replacing these fan trays, see the following sections:
•
•

Required Tools

You need a flat-blade or number 2 Phillips-head screwdriver to loosen or tighten the captive screws on
the fan tray.

Replacing a Cisco Nexus 7010 System Fan Tray

The Cisco Nexus 7010 system fan tray is designed to be removed and replaced while the system is
operating, but you should replace the fan tray within a couple of minutes to maintain the designed system
airflow.
When removing the fan tray, keep your hands and fingers away from the spinning fan blades. Let the
Warning
fan blades completely stop before you remove the fan tray. Statement 258
To replace a Cisco Nexus 7010 system fan tray, follow these steps:
OL-18634-01
1-4).
Required Tools, page 8-13
Replacing a Cisco Nexus 7010 System Fan Tray, page 8-13

Replacing a Cisco Nexus 7010 System Fan Tray During System Operations

Cisco Nexus 7000 Series Hardware Installation and Reference Guide
8-13