Cisco Nexus 7000 Series Hardware Installation And Reference Manual page 66

Installing the Cable Management Assemblies
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
Figure 3-9
4
1 Upper cable management assembly
3 Position the assembly so that the two upper
hooks on the rack-mount bracket fit inside the
two holes on the assembly, and then slide the
assembly down so that it is held by the hooks.
Repeat Step 1 and Step 2 to loosely attach a lower cable management assembly and an upper cable
Step 3
management assembly to the right rack-mount bracket. When completed, the chassis will appear as
shown in
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
3-16
Attaching the Upper Left Cable Management Assembly to the Left Rack-Mount
Brackets
2 1
3
3
Figure 3-10.
Chapter 3 Installing a Cisco Nexus 7018 Chassis
2 Left rack-mount bracket
4 Loosely fasten the assembly to the
rack-mount bracket with four M4x10 screws.
Do not tighten these screws.
OL-18634-01