Cisco Nexus 7000 Series Hardware Installation And Reference Manual page 38

Installing the Bottom-Support Rails on the Rack
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
Figure 2-1
1
For the first and heaviest Cisco Nexus 7010
chassis installed in a rack, position two
bottom-support rails at the lowest RU on the
rack.
3 Allow at least 36.75 inches (93.4 cm) (21 RU)
for each Cisco Nexus 7010 system.
Use a Phillips screwdriver to screw in three M6 x 19 mm or 12-24 x 3/4 in. Phillips screws on each end
Step 2
of each rail (using a total of 12 screws for both brackets) as shown in
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
2-6
Positioning the Bottom-Support Rails
3
3
1
Chapter 2 Installing a Cisco Nexus 7010 Chassis
2
For the second Cisco Nexus 7010 chassis
installed in a rack, position two
bottom-support rails immediately above the
first installed device.
Figure 2-2.
2
OL-18634-01