Cisco Nexus 7000 Series Hardware Installation And Reference Manual page 49

Chapter 2 Installing a Cisco Nexus 7010 Chassis
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
Figure 2-10
Push the card all the way into the reader.
Step 2
If the card does not fit easily into the reader, flip the card so the bottom edge is on top, and try pushing
the card into the reader.
Wait for the reader LED to turn green and for a message to appear on the console as follows:
Step 3
If you are installing a card into the log flash reader, the message will end with "logflash:online."
•
switch# 2008 Mar 15 08:00:00 switch %$ VDC-1 %$ %IDEHSD-2-MOUNT: logflash:online
• If you are installing a card into the expansion flash reader, the message will end with "slot0:online."
switch# 2008 Mar 15 08:00:00 switch %$ VDC-1 %$ %IDEHSD-2-MOUNT: slot0:online
If you see an offline message or do not see a message, either the card is not fully pushed into the
•
reader or it is improperly formatted.
switch# 2008 Dec 1 12:00:00 switch %$ VDC-1 %$ %IDEHSD-2-UMOUNT:logflash:offline
Make sure that the card is fully inserted inside the reader. If the card is fully inserted, either format
the card (see the Cisco NX-OS Fundamentals Configuration Guide, Release 4.0) or replace the card
with another card that is properly formatted for the reader (see the
Card" section on page
OL-18634-01
Aligning a CompactFlash Card to its Reader
8-15).
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
Installing and Formatting CompactFlash Cards
"Replacing a CompactFlash
2-17