Installing The Dial-Up Adapter; Windows 95/98/Me; Windows Nt/2000 - Nextel iR1200 Administrator's Manual

Installing the Dial-Up Adapter

The following table describes the steps for installing the Dial-Up Adapter.

Windows 95/98/ME

1 From the Select Network Adapter window, highlight
Dial-Up Adapter in the Network Adapters list.
2 Under Manufacturers, highlight Microsoft. Click OK.
3 The Select Network Component Type window opens.
Highlight Adapter. Click Add.
4 The Select Network Adapters window opens.
5 To verify that the adapter was added, from Start, select
Settings.
•
Select Control Panel.
•
Click Network.
•
Look for Dial-Up Adapter on the Network
Configuration screen.

Windows NT/2000

The Dial-Up Adapter may not have been included in the standard installation.
The following steps describe how to check that TCP/IP is in fact installed, and
if necessary add the TCP/IP protocol.
NOTE: This may require that you contact your IT Representative or
System Administrator.
1 Select Start Settings Control Panel. The Control
Panel window opens. Double click on Network and Dial
Up Connections.
2 The Network and Dial Up Connections window opens.
Double click on Make New Connection which brings up
RFM-4002-5015 Rev 3
Setting Up Windows Components
39