S-Registers; Programming The S-Register - Nextel iR1200 Administrator's Manual

In this chapter, you are will learn about S-registers and how to configure
registers for your iR1200 modem.
This chapter includes:
S-Register
Programming S-Register
Reading S-Register
Supported S-Register

S-Registers

S-registers are memory locations in the modem that you can program to meet
your communication needs. S-register parameters are numbered from 0 (zero)
to 255. Since many of the registers are reserved for internal operation purposes,
you are allowed to customize only a subset of the modem's register.

Programming the S-Register

The following table describes the steps to program an S-Register.
1 From the command mode of your communication software,
type ATSn=x where n is the number of the S-register you
wish to customize and x is the value that you wish to assign
to that register.
2 Press ENTER to execute the command.
You may experience undesirable consequences if you
!
modify the S7 or S10 registers from their set default
values. For optimal performance, it is recommended
that you use the default values set for these two
registers.
RFM-4002-5015 Rev 3
S-Registers
S-Registers
Page 87
Page 87
Page 88
Page 88
87