Communication Indicators - Nextel iR1200 Administrator's Manual

5 Plug the AC power cord into the 2-prong polarized power
jack located on the rear panel of the modem. Plug the other
end into a 120VAC-wall outlet.
6 Insert the ignition bypass plug into the 4-prong polarized
IGNITION jack located on the rear panel of the modem (refer
to Figures 2 and 3 on page 11).
7 The STATUS Led light will be solid RED. This indicates that
the modem is attempting to register with the iDEN network.
8 A blinking green light indicates that the modem has
successfully registered with the iDEN network.

Communication Indicators

Your iR1200 modem is equipped with the LED indicators (located on the front
panel of the modem – see Figure 4) that identify various communication
functions.
The following table contains descriptions of the LED indicators and their
functions.
Signal Color
Tx Blinking
Green
Rx Blinking
Green
RTS Green
(Off)
RFM-4002-5015 Rev 3
Indication
Modem is transmitting data to the
computer data terminal (DTE).
Modem is receiving data from the
computer. Modem is receiving data from
the DTE.
Request To Send from computer (DTE) is
asserted (not asserted).
Getting Started
17