Heat & Glo ESCAPE-I35-C Owner's Manual page 38

1 1
Figure 4. Log #2
Log #2 (SRV2202-701): See Figure 2 for additional references. Position Log #2 as shown in Figure 4. Mate Log #2 with
the right corner of the burner as shown. Pull the log forward and to the left until it locks into position.
LOG CONTACTS LEFT LOG CONTACTS LEFT
GRATE TINE GRATE TINE
3
Figure 5. Log #3
Log #3 (SRV2202-704): See Figure 2 for additional reference details. Locate the log slot on the bottom right end of Log
#3. Mate the log slot with the left log pin. Rotate the left end of the log counterclockwise, until it contacts the grate tine.
Log #4 (SRV2202-703): See Figure 2 for additional reference details. Locate the log slot on the bottom left end of log #4.
Mate the log slot with the right log pin. Rotate the right end of the log clockwise, until it contacts the grate tine.
GLASS ROCK GLASS ROCK
Figure 7. Glass Rock in Place
Glass Rock (2201-853): Once Log #3 and Log #4 are installed, fi ll each light tray with the glass rock.
WARNING! Risk of Explosion! DO NOT place glass rock on the burner surface. DO NOT place glass rock directly over
burner ports. Improperly placed glass rock interferes with proper burner operation.
38
FLAT SPOT FLAT SPOT
FOR LOG#6 FOR LOG#6
LOG MATES LOG MATES
WITH CORNER WITH CORNER
OF BURNER OF BURNER
2 2
LOG HANGS OVER LOG HANGS OVER
ONTO BURNER TOP ONTO BURNER TOP
Heat & Glo • Escape-I35-C, Escape-I30-C • 2201-901 Rev. H • 5/12
Figure 6. Log #4
LOG CONTACTS RIGHT LOG CONTACTS RIGHT
GRATE TINE GRATE TINE
4