Heat & Glo ESCAPE-I35-C Owner's Manual page 37

H. Install the Log Assembly
Log Set Assembly: LOGS-I35FB
Models: ESCAPE-I35FB, ESCAPE-I35FB-LP
ESCAPE-I35-C, ESCAPE-I35LP-C
CAUTION: Logs are fragile, handle with care.
5 5
1 1
3 3
Figure 1. Log Set Installed
FLAT SPOT FLAT SPOT
FOR LOG #5 FOR LOG #5
1
REST LOG ON REST LOG ON
BURNER LEDGE BURNER LEDGE
Figure 3. Log #1
Log #1 (SRV2202-702): See Figure 2 for additional references. Position Log #1 as shown in Figure 3. Rest the left and
right ends of Log #1 on the burner ledge. The pilot bracket will support the center of the log. Pull the left end of the log
forward into position.
6 6
2 2
4 4
LOG RESTS ON LOG RESTS ON
PILOT BRACKET PILOT BRACKET
Heat & Glo • Escape-I35-C, Escape-I30-C • 2201-901 Rev. H • 5/12
1 1
SRV2202-702 SRV2202-702
3 3
SRV2202-704 SRV2202-704
6 6
SRV2202-706 SRV2202-706
PILOT BRACKET PILOT BRACKET
BURNER LEDGE BURNER LEDGE
LIGHT TRAYS LIGHT TRAYS
GRATE TINES GRATE TINES
Figure 2. Reference Points
2 2
SRV2202-701 SRV2202-701
4 4
SRV2202-703 SRV2202-703
5 5
SRV2202-705 SRV2202-705
BURNER LEDGE BURNER LEDGE
LOG PINS LOG PINS
GRATE GRATE
BAR BAR
37