Removing and Replacing Components
Removing and Replacing the QuickFind Diagnostic Board
Step 5. Unplug the cable from the connector on QuickFind diagnostic board and remove the board from the
chassis. Figure 4-45 shows how to remove the QuickFind diagnostic board.
Figure 4-45 Removing and Replacing the QuickFind Diagnostic Board
Replacing the QuickFind Diagnostic Board
To replace the QuickFind diagnostic board, follow these steps:
Step 1. Gently plug the cable into the QuickFind diagnostic board connector.
Step 2. Replace the QuickFind diagnostic board into the cover by snapping it into place.
Step 3. Turn the assembly over and snap into place on top of the power supply cage.
Step 4. Replace the top cover. See "Replacing the Top Cover" on page 44.
Step 5. If rack mounted, slide the HP server into the rack until it stops. See "Inserting the Server into the
Rack" on page 39.
110
Cover
QuickFind
diagnostic board
Chapter 4