HP Integrity rx4640 User's & Service Manual page 185

Step 7. You may display (and optionally change) any SCSI parameters listed below for the channel of the
SCSI interface, or restore its SCSI parameters to their default values.
• SCSI ID
• Maximum data transfer rate
• Bus width
• Whether the SCSI interface is bootable (driver support)
• Avoid bus resets (secondary cluster server)
• Restore Defaults
Step 8. Use the arrow keys to navigate to the appropriate SCSI parameter.
Step 9. Use the plus (
Step 10. Press to exit the
Esc
• Cancel the exit from the screen (to stay in the
SCSI interface)
• Save the changes you made and then exit the screen
• Discard the changes you made and then exit the screen
Step 11. Move the cursor to the action (cancel, save, or discard) you want to take; press
If you selected cancel, you remain in the
interface. You can still change the channel's parameters listed above.
If you selected save or discard, you are placed in the EFI SCSI Setup Utility's main menu.
CAUTION
Step 12. Press to exit the main menu and the EFI SCSI Setup Utility.
Esc
Step 13. Select the option for exiting the utility.
Step 14. When you are prompted to, press
prompt.
Step 15. At the EFI shell prompt, enter the reset command:
The server starts to reboot. This is required to cause the new SCSI setting.
Appendix C
•
Disconnect
•
SCSI Timeout
•
Queue Tags
•
Format
•
Verify
Changing any of these fields can cause unpredictable results.
) and minus ( ) keys to scroll through the values.
+ -
Adapter Properties
Do not select the <Global Properties> option on the main menu.
Enter
screen. You are given these choices:
Adapter Properties
screen for the channel of the SCSI
Adapter Properties
to stop the SCSI interface; you are now back at the EFI shell
Specifying SCSI Parameters
screen for the channel of the
.
Enter
Utilities
185