Powering Off and Powering On the Server
Power States
Power States
The server has three power states:
•
Standby power
•
Full power
•
Off
Plug the power cord into the appropriate receptacle on the rear of the chassis to achieve the standby power
state; the front panel power button is not turned on. Full power occurs when the power cord is plugged into
the appropriate receptacle, and either the power is activated through the iLO MP PC command, or the power
button is activated. In the off state, the power cords are not plugged in. Table 3-1 lists the server power states.
Table 3-1
Power States
Power Cable
Power States
Plugged Into
Receptacle?
Standby power
Yes
Full power
Yes
Off
No
NOTE
If the power restore feature is set to
automatically powers on to the full power state.
Powering Off the Server
Power off the server using the following methods if the server is in either the standby or full power state:
•
iLO MP PC command
•
Power button
Powering Off the Server Using the iLO MP
To power off the server through the iLO MP, follow these steps:
Step 1. Gracefully shut down the operating system. See Appendix B, "Booting the Operating System," on
page 141, or your operating system documentation for more information.
Step 2. Initiate a console session, and access the
Step 3. Enter CM to access the
34
Power Activated through the
iLO MP PC Command; or
Front Panel Power Button
Activated?
No
Yes
No
Always On
iLO MP Main Menu
.
Command Menu
AC Voltage
Applied
Yes
Yes
No
through the iLO MP PR command, the server
.
DC Voltage
Applied
No
Yes
No
Chapter 3