Figure 4-27 Inserting Pci-X Card - HP Integrity rx4640 User's & Service Manual

Figure 4-27 Inserting PCI-X Card
Online Deletion (OL-D)
To delete a PCI-X card from an occupied slot, follow these steps:
Step 1. If rack mounted, slide the HP server out from the rack until it stops. See "Extending the Server
from the Rack" on page 39.
Step 2. Remove the top cover from the chassis. See "Removing the Top Cover" on page 43.
Step 3. Press the attention button located on the OLX divider that controls the affected slot—the power
LED starts to blink. Wait until the power LED goes from blinking to steady-off.
NOTE
Chapter 4
After pushing the attention button, you have 5 seconds to cancel the operation by
pushing the attention button again.
Removing and Replacing Components
Removing and Replacing Hot-Plug PCI-X Cards
79