Held Event - Panasonic Selection 470 Programmer's Manual

Service Parameters:

Held Event

Function: CSTAHeldEvent
Direction: C ← S
Functional Description:
Service Parameters:
32
The DBS TSAPI driver has the ability to intercept failed events due to a party disconnect-
ing from a call.
monitorCrossRefID
failedConnection
failingDevice
calledDevice
localConnectionInfo
cause
The Held Event Report indicates that a DBS extension places a call on hold. This includes
the hold for conference and transfer.
Placing a call on hold can be done either manually at the station or via a Hold Service
request.
monitorCrossRefID
heldConnection
holdlingDevice
localConnectionInfo
cause
Issued April 2000
Section 470 - TSAPI Programmer's Guide
[mandatory] contains the handle to the monitor request for
which this event is reported.
[mandatory - supported] specifies the callID that failed.
[mandatory - supported] specifies the device that failed.
[mandatory- partially supported] specifies the called device.
[optional - supported] specifies the connection state of the
monitored device for this call.
[optional - supported] specifies the reason for this event.
[mandatory] contains the handle to the monitor request for
which this event is reported.
[mandatory] specifies the endpoint where hold was activated.
[mandatory] specifies the extension that placed the call on
hold.
[optional - supported] specifies the connection state of the
monitored device for this call.
[optional - not supported] specifies the reason for this event.
DBS-92-470