Connection Cleared Event - Panasonic Selection 470 Programmer's Manual

Connection Cleared Event

Function: CSTAConnectionClearedEvent
Direction: C ← S
Functional Description:
A Connection Cleared Event Report is generated in the following cases:
• When a DBS extension drops from a call.
• When a DBS trunk drops from a call.
• When a monitored extension is involved in a call dissolved by a CSTA Clear Call request
A Connection Cleared Event Report is not generated in the following cases:
• A party drops as a result of a transfer operation.
28
primaryOldCall
secondaryOldCall
confController
addedParty
conferenceConnections
localConnectionInfo
cause
The Connection Cleared Event Report indicates that a device in a call disconnects or is
dropped.
or a CSTA Connection Cleared request.
Issued April 2000
Section 470 - TSAPI Programmer's Guide
[mandatory] specifies the callID of the call that was
conferenced. This is usually the held call before the
conference. This call ended as a result of the conference.
[mandatory] specifies the callID of the call that was
conferenced. This is usually the active call before the
conference. This call ended as a result of the conference.
[mandatory] specifies the device which is controlling the
conference. This is the device which setup the conference.
[mandatory] specifies the new conferenced in device.
• If the device is a DBS extension, the extension is specified.
• If the party is a DBS trunk, the trunk number is given.
[optional - supported] specifies a count of the number of
devices and a list of up to four connectionIDs and up to four
deviceIDs which resulted from the conference.
• If a device is a DBS extension, the extension is specified.
• If a device is a DBS trunk, the trunk identifier is given.
[optional - not supported] specifies the connection state of the
monitored device for this call.
[optional - not supported] specifies the reason for this event.
DBS-92-470