Connection; Handling The Fabric Hose; Using The Common Interface Module; Switching On - Loewe XELOS A 42 Operating Instructions Manual

First installation
If the reception conditions are good, then a room antenna may be used
for DVB-T. Passive and active room antennas are available on the market.
The power is supplied for an active antenna via the antenna connection.
For automatic programming or in "TV Menu – Connections – Antenna
DVB – Antenna DVB-T," the distribution voltage (5 volts) is to be set
correspondingly.
It may be practical to use a nondirectional antenna. If the location is
outside the normal transmitting range, then a unidirectional antenna may
also be used to improve the reception quality.
You can find out more on the digital stations that can be received in your
area at your specialist dealer.
If a Xelos A32/37/42 was retrofitted with a PIP tuner or if this is already
integrated in a set with a digital recorder, then plug the antenna into the
antenna input of the PIP tuner and connect the PIP tuner output with the
ANT-TV socket (Tuner 1). See illustrations on page 7/8.
If a Digital Satellite Tuner 1 has been retrofitted, connect your satellite
antenna system to the ANT-SAT socket.
If a Digital Satellite Tuner 2 has been retrofitted (only in conjunction with
the Digital Recorder+), then connect one antenna cable each, for example
from the antenna switch or from the twin LNC, to both SAT sockets.
When laying the cable, use the cable clips affixed beneath the TV set.
Replace the connection cover on the TV set.
hose with the cables to the connection boxes. This provides you with an
elegant solution when laying cables.
The diameter of the fabric hose increases when you push it together
lengthwise (see illustration). This makes it easier for you to push through
cables with plugs.
Handling the
fabric hose
Use the fabric hose included
with Xelos A 32/37/42 to lay
the mains cables, antenna
cables or cables from other
electronic components
systematically; then lead the

Using the common interface module

(only for sets with CI slot)
In order to be able to receive encrypted digital stations, the common
interface module (CI module) and the smartcard both have to be inserted
into the corresponding slot of your TV set. You can purchase the CI module
and smartcard at your specialist dealer. You can find the slot on the back of
your TV set, see the illustrations on pages 6 – 8.
1. Make sure the TV set is switched off with the mains switch on the set,
or pull the mains plugs.
2. First push the smartcard into the CI module as far as it will go. Insert
it so that the side with the golden contact chip faces the side of the
module printed with
the supplier's brand
logo. Printed arrows
indicate how to insert
the card. Also follow the
installation instructions
included with the
smartcard.
✳
3. Slide the CI module carefully into the slot with
the contact side facing the front. The logo on the
common interface module should be visible.
Make sure the module is not twisted in the
process. Do not use force.
When the module locks, the eject button is
pressed outwards.
✳
The CI module and the smartcard are not included
in the scope of delivery for this set; you can usually
obtain them at your specialist dealer.

Switching on

Press the mains switch (for Xelos A 32/37, the set
switches on immediately, the green indicator lamp
lights up).
For Xelos A 26/42:
The red indicator on the set now lights up (standby mode).
Switch on the set using the switch integrated in the
indicator.
After switching on, it takes about 2 minutes for the screen to reach full
brightness due to the LCD technology.
Eject button
CI module
13