Operating Additional Equipment; Login And Connect Equipment - Loewe XELOS A 42 Operating Instructions Manual

Operating additional equipment

Login and connect equipment

You have logged in and connected all connected equipment in the
initial start-up. If you want to connect other equipment or disconnect
equipment, call the connection wizard.
Call up the TV menu
OK
Select "Connections"
OK
Select the submenu line
Select "New devices/modifications" and ...
OK
Call with OK.
State what equipment you want to connect. State whether a piece of
audio equipment is to be connected (more details as of page 35). The
connection wizard then shows you which sockets you should connect this
equipment to. Then connect the equipment to these sockets according to
the connection diagram.
Connecting video/DVD recorders
In addition to the connection via the Euro-AV sockets, you also have to
connect the antenna (only for terrestrial antenna or cable systems) through
the VCR/DVD recorder to the TV set. The antenna signal is then available to
the video/DVD recorder and the TV set.
Note: Use Euro-AV cables with right-angled plugs as shown.
32
AV1 ANT-TV
ENTREE
ANTENNE
EURO AV2
DECODER
AUDIO
AERIAL
SORTIE OUT
G L
SORTIE
EURO AV1
ANTENNE
AUDIO/
VIDEO
D R
RF OUT
Search for and store the station of the video recorder (if no Euro-AV
cable is available)
Switch on the test station on the VCR or insert a recorded tape and start
playback. In some video recorders the station must be switched on by
activating the modulator.
Then call the AV selection on the TV set with 0 AV. Select the menu item
"VIDEO" in the AV selection and call using OK.
To prevent "normal" TV stations being found in the search, pull out the
antenna plug from the antenna input of the VCR temporarily (the cable to
the antenna system).
If you cannot see the test station or playback from the cassette, the VCR is
transmitting on a different channel. You then have to search for the station
or set it manually.
1. Call the TV menu with the MENU button.
2. Select the "Settings" menu item with
3. Select the line below using
4. Select the line below using
and call this menu using OK.
5. Enter channel "E30" under the "Channel" menu item (UHF range, select
in this menu above, if necessary).
6. Start search with the blue colour key.
7. If the station has been found, enter the name VIDEO, confirm with OK
and save with the red colour key.
8. A list of the stored stations is displayed.
9. Select 0 (VIDEO) here and overwrite this station storage location using
the red colour key.
10. Hide the menu again using the END button.
Plug the antenna plug back in.
If you now get interference because a TV station is transmitting on the
same channel as the VCR station, you have to change the transmitting
station on the VCR and search for the VCR station on the TV again.
.
and use to select "Stations".
and select "Manual adjustment" using