Initial Installation; Batteries; Connection; Switching On - Loewe Spheros 32 HD Operating Instructions Manual

Initial installation

Batteries

To insert or change the batteries, press the
point marked by an embossed arrow. Push the
cover of the battery compartment down and
remove it. Insert the batteries of the alkaline
manganese type LR 03 (AAA) with the correct
polarity (+/-).
+
Then push the cover back on.
Note on disposal of batteries:
The original batteries do not
contain any pollutants such as
cadmium, lead and mercury.
Used batteries do not belong in
the domestic waste. They must
be taken to the appropriate
collection points according to
the national laws. Ask your
dealer.
31963_021_RC3_GB
Connecting
Antenna
Connect your antenna or cable system to the
UHF/VHF antenna socket on the back of the
Signal Box.
• In sets with the "Digital-TV Upgrade Kit 2
Sat/Twin-Sat CI- or CIP" connect the Sat
antenna cable to the "ANT-1" and "ANT-2"
sockets, in this way you can receive two
satellite programs simultaneously, e.g. for
PIP display, see fig. on page 9.
• In sets with "Digital-TV Upgrade Kit 2-T/S"
connect the antennae to the Signal Box as
shown below.
+
ANT-1
PIP UH
Power mains
After connecting the flat screen to the Signal
Box, connect both devices to 230V/60Hz mains
sockets.

Switching on

Press the On/Off button so that it is pressed in.
Due to the LCD technology it takes about 2
minutes to reach full brightness.
9
AV 1
AV 2 ( RGB )
DIGITAL
AUDIO IN1
L R
R L R L R Center Sub
OUT AUDIO IN 3 SOURROUND
RC5/ IR-
SERVICE
RC6 Lin
.
Switch on/off
14.01.2005, 10:40 Uhr

Automatic programming

Automatic programming of the TV set is started
the first time you switch it on. Follow the
menus.
First you have to select the menu language for
your set. Then you specify which antenna you
have connected to your TV and in what country
you are using it. Then you start the station
search. The TV set searches for, saves and sorts
all programs which are freely receivable on
your antenna system.
You then see a list of the stored stations in
which you can mark your favorites. Finally log
in your video recorders, decoders, Loewe audio
system and Home Automation with the
connection wizard and connect these to the TV
set according to the illustrated connection plan.
Select the settings with the
OK
arrows on the ring ...
... confirm the settings with
OK. You then move on to the
OK
next menu ...
... press this button if you want
information about the settings.
You can repeat initial installation at any time,
e.g. after moving house. Call the index in the
main information (i button). Then select the
item "Repeat initial installation". Then start
"Initial installation" with OK.
9