Initial Installation; Batteries - Remote Control; Connection; Switching On - Loewe Planus 4781 ZW Operating Instructions Manual

Initial installation

Batteries – remote control
To insert or change the batteries, press the
point marked by an embossed arrow. Push
the cover of the battery compartment down
and remove it. Insert the batteries of the alka-
line manganese type LR 03 (AAA) with the
correct polarity (+/–).
Then push the cover back on.
Note on disposal of batteries:
The original batteries do not
contain any pollutants such as
cadmium, lead and mercury.
Used batteries do not belong in
the domestic waste. They must
be taken to the appropriate
collection points according to the
national laws. Ask your dealer.

Connection

Mains
Connect the TV set to a 230V/50–60 Hertz
outlet.
Antennae
Connect your antenna or cable system to the
PIP antenna socket.
Plug the antenna plug protruding from above
the PIP antenna socket into the antenna socket
for the VHF/UHF tuner.
+
If your TV set is equipped with one or two
satellite tuners, connect the SAT antennae to
the SAT sockets (see figure on page 5).
+

Switching on

The on/off switch of the TV set can be found
behind the cover of the control panel. Open the
control panel flap.
DIG IN
1
RC5/RC6
SAT
SERVICE
IR
2
CTRL
SAT A/D VGA DIG OUT
AUDIO IN
AV3
AV1 AV2/RGB
R
AUDIO OUT
VHF/UHF L
SUR
R
C
SUBWOOFER
STAND L
SUB
Press the On/Off button so that
it snaps in.
Initial installation
Automatic programming of the TV set is started
the first time you switch it on. Follow the
menus.
First you have to select the menu language for
your set. Then you specify which antenna you
have connected to your TV and in what country
you are using it. Then you start the channel
search. The TV searches for, stores and sorts all
the channels which your antenna system re-
ceives. You then see a list of the stored chan-
nels in which you can mark your favourites.
Then you log in your video recorders and con-
nect them as shown in the wiring diagram.
Select the settings with the
arrows on the ring ...
... confirm the settings with
OK
OK. You then move on to the
next menu ...
... press this button if you want
i
information about the settings.
You can repeat initial installation at any
time, e.g. after moving house. Launch the
index in the main information (i button). Then
select the item "Repeat initial installation".
Then start "Initial installation" with OK.
9