Configuring I/O Settings; Table 1-12 Dynamic Variables - Honeywell HCX13M Operator's Manual

Configuring I/O Settings

Document 800-01794 Rev A
04/08
Dynamic Variables
Dynamic variables may be used within entries to certain text fields. These variables will be
replaced with the appropriate values, as in
Table 1-12 Dynamic Variables
Result Description
message
$SH The hardware address of the camera
$SI The IP address of the camera
$SN The camera name, as specified on the Network Settings screen
(see "Network Setup" on page 29)
$ST The current time, in 08:14:23 format
$SD The current date, in Wed Mar 19 2008 format
$SC Company name (for example, Honeywell)
$SP Product name (for example, HCX13M)
$SV The version of operating software on your camera
$SM The domain name, as specified on the Network Settings screen
(see "Network Setup" on page 29)
$FN The name of the file that your camera is accessing
Use these settings to configure the behavior of the relay output of your camera. To test
your relay output configuration, click
HCX Series Network IP Camera Operator Guide
Table 1-12 below.
at the bottom of the screen.
41