Honeywell HCX13M Operator's Manual page 40

40
FTP Status—Troubleshooting
This status dialog shows either success or the reason for failure of the last FTP attempt.
Test your settings by clicking
in the status area.
Result Description
message
Success File transfer successful
Testing Attempting file transfer
Login Logon failed. The username and/or password is incorrect.
CWD Failed to change to ftp path directory
Send File transfer failed. This is usually due to a network error or it may
be that the disk is full.
MKD Failed to create the directory specified in the FTP file path setting.
This may be due to lack of permission, a disk-full condition, or an
invalid character in the file path.
Memory Your camera ran out of memory. Check memory statistics by
telnetting to your camera, then enter show server at the prompt.
Connect Failed to connect to FTP server. Try pinging the server to see if your
camera can gain access. Also check the hostname to make sure
the name or IP address is valid.
Name Your camera could not match the FTP hostname to an IP address.
resolution Check for correct nameserver and domain name settings on the
Network Settings page. Also try pinging the FTP server hostname.
Socket create Your camera could not create a network socket.
Open Failed to open the local trigger file.
1. Telnet to your camera, enter disk cd /ram at the prompt, then
press return.
2. Enter disk ls -l, then press return.
Note the names and modification times of any image files in this
directory.
3. Enter test trigger input, then disk ls -l again.
Check if these files have updated by comparing their current and
past modification times.
Configuration The FTP settings on your camera are misconfigured. Check for
missing entries.
None No FTP attempt has yet been made
Command The FTP host did not understand a command sent by the camera.
. One of the following result messages displays