Ddm (Ri And Ei Mode Only) - D-Link xStack DGS-3120 Series Reference Manual

xStack® DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch Web UI Reference Guide

DDM (RI and EI Mode Only)

This folder contains windows that perform Digital Diagnostic Monitoring (DDM) functions on the Switch. There are
windows that allow the user to view the digital diagnostic monitoring status of SFP modules inserting to the Switch
and to configure alarm settings, warning settings, temperature threshold settings, voltage threshold settings, bias
current threshold settings, TX power threshold settings, and Rx power threshold settings.
DDM Settings
The window is used to configure the action that will occur for specific ports when an exceeding alarm threshold or
warning threshold event is encountered.
To view the following window, click System Configuration > Port Configuration > DDM > DDM Settings, as
shown below:
The fields that can be configured are described below:
Parameter
Trap State
Log State
Unit
From Port / To Port
State
Figure 2-5 DDM Settings window
Description
Specify whether to send the trap, when the operating parameter exceeds the alarm or
warning threshold.
Specify whether to send the log, when the operating parameter exceeds the alarm or
warning threshold.
Select the unit to be configured. (EI Mode Only)
Select a range of ports to be configured.
Use the drop-down menu to enable or disable the DDM state
9