Maintenance And Troubleshooting - Pro-Form ZE5 User Manual

MAINTENANCE AND TROUBLESHOOTING

Inspect and tighten all parts of the elliptical exerciser
regularly. Replace any worn parts immediately.
To clean the elliptical exerciser, use a damp cloth and
a small amount of mild soap. IMPORTANT: To avoid
damage to the console, keep liquids away from
the console and keep the console out of direct
sunlight.
CONSOLE TROUBLESHOOTING
If the console displays become dim, the batteries
should be replaced; most console problems are the
result of low batteries. See assembly step 11 on page
11 for replacement instructions.
If the handgrip pulse sensor does not function proper-
ly, see step 5 on page 18.
HOW TO ADJUST THE DRIVE BELT
If you can feel the pedals slip while you are pedaling,
even when the resistance is adjusted to the highest
level, the drive belt may need to be adjusted.
To adjust the drive belt, you must remove the pedal
arms, the pedal discs, and the left shield (see the
instructions below).
See EXPLODED
DRAWING B on
page 30. Remove
the M8 x 18mm
Patch Screws
(80), the Pedal
Arm Caps (30),
and the M8
Washers (33),
and then remove
the Left and Right
Pedal Arms (14,
49).
Using a flat screwdriver, release the tabs on the right
and left Pedal Discs (26) and remove the Pedal Discs.
14
26
49
Remove the four
indicated M4 x
38mm Screws
(86) from the
Right Shield (45).
Remove the M4 x
19mm Screws
(25) from the Left
Shield (44) and
then remove the
Left Shield.
Next, loosen the
Pivot Screw (88).
Then, tighten the
Drive Belt
Adjustment Screw
(72) until the
Drive Belt (46) is
tight.
When the Drive
Belt (46) is tight,
tighten the Pivot
Screw (88).
Then, reattach the left shield, the pedal discs, and the
pedal arms.
23
45
86
44
25
46
88
72