Remove Projector Front Feet; Install Anamorphic Lens Motor; Rs-1100 Ultra With Autoscope Lens Motor - Bottom View - Runco RS-1100 CineWide Owner's Operating Manual

Installation
Remove Projector Front
Install Anamorphic Lens
Motor
Place the projector upside down on a blanket
Feet or other soft surface. Then, remove the two
front feet by turning them counter-clockwise.
Note
Line up the eight mounting holes on the lens motor housing with those on the bottom of
the projector. Secure the motor to the projector with the eight screws provided for this
purpose, as shown in Figure 3-6.
Figure 3-6. RS-1100 Ultra with AutoScope Lens Motor – Bottom View
Caution
The anamorphic lens mounting kit is partially pre-assembled at the
factory – the AutoScope lens motor and lens mounting assemblies
are both fully assembled.
DO NOT OVER-TIGHTEN THE SCREWS.
22 Runco RS-1100 Series Owner's Operating Manual