Vertical And Horizontal Position; Vertical And Horizontal Lens Shift; Vertical Lens Shift (Example Only) - Runco RS-1100 CineWide Owner's Operating Manual

Installation
Vertical and Horizontal
Position
Vertical and Horizontal
Lens Shift
Proper placement of the projector relative to the screen will yield a rectangular,
perfectly-centered image that completely fills the screen.
Ideally, the projector should be positioned perpendicular to the screen and in such a way
that the lens center and screen center are aligned with each other, as shown in Figure 3-2.
Ceiling Installation
Height
Lens Center
x
Floor Installation
Height
Lens Center
x
Figure 3-2. Projector Placement
If it is not possible to align the projector and screen as shown in Figure 3-2, you can use
the lens shift (LENS) controls on the projector remote to center the image on the screen.
Lens shift is generally expressed as a percentage of the screen height or width, as shown
in Figure 3-3 and Figure 3-4.
to lens center =
approx. 5-6" (depending
on the amount of lens shift)
Note: This is a general example of lens shift. Lenses vary in their shift capabilities. No particular
lens or projector is used in this example.
Figure 3-3. Vertical Lens Shift (Example Only)
Ceiling
Projection Distance
Screen Lens Center
Screen Lens Center
Projection Distance
Floor
Base plate
18 Runco RS-1100 Series Owner's Operating Manual
Screen Center
0%
50% Height
Lens Shift
(0.5 x H)
100% Height
Lens Shift
(1.0 x H)
150% Height
Lens Shift
(1.5 x H)