Preset Mode; Manual Mode - Chauvet Obey 6 User Manual

Preset Mode

Manual Mode

Obey™ 6 User Manual Rev. 1
Preset mode uses the <COLORS/CHASES> buttons to select a specific color, as labeled on the
board.
To use Preset mode, do the following:
1. Select lights by pressing <FIXTURES> buttons. The LEDs of the selected lights turn on.
2. Press <Preset>. The Preset LED turns on.
3. Press a <COLOR/CHASES> button.
4. Use <Master Dimmer> to set the brightness.
5. Use <Fade Time> to set the timing of the Master Dimmer function.
6. Use <Strobe Speed> to strobe the color. See
To exit Preset mode, press any other mode button.
·
If the lights are behaving oddly, check that <Fade Time> is half way up. Also, check that
<Master Dimmer> is all the way up.
·
See Tips and Tricks
Manual mode turns the faders and the buttons above them into individual color controls. The faders
mix colors, and the buttons instantly turn on colors to full, but only for the time the button is pressed.
In Manual mode, intensity is controlled by the color mixing. For lower intensities, position the faders
towards the bottom. For higher intensities, position the faders towards the top.
To use Manual mode, do the following:
1. Select lights by pressing the <FIXTURES> buttons. The LEDs of the selected lights will turn on.
2. Press <Manual RGBAWUV>. The Manual RGBAWUV LED turns on
3. Use the faders to mix a color.
4. Use the buttons to momentarily turn on a color to full.
To exit Manual mode, press any other mode button.
Strobe Function
for more information.
4. Operation | Preset Mode
for more information.
Page 15 of 22